Garden Stone Pavement Sealer Driveway DRY Aqua Natural Finish for Patios Floors

Name: Garden Stone Pavement Sealer Driveway DRY Aqua Natural Finish for Patios Floors
SKU: 33430
Availability: InStock

We hold MSDS (Material Safety Data Sheet) for all hazardous goods.No MSDS is required by EU regulation to all neutral products however we can provide on request with wholesale orders.

This service is available upon request as a PDF file.

All our products are labeled in accordance with the new European regulations for Classification, Labeling and Packaging (CLP).

Size

Clear

From £17.09

— OR —

Stone sealer STRONG SOLIDO

Capacity: 5L, 1L,

We hold MSDS (Material Safety Data Sheet) for all hazardous goods.No MSDS is required by EU regulation to all neutral products however we can provide on request with wholesale orders.

This service is available upon request as a PDF file.

All our products are labeled in accordance with the new European regulations for Classification, Labeling and Packaging (CLP).

Density – 1g / cm³

Appearance – colorless liquid

Drying time – approx. 30 min / 20 ° C

Impregnation effect -24 hours

Coverage – 1L, about 10m²

Usage method:

Procedure: Apply an appropriate amount of the product evenly on the prepared surface with a roller, brush or spray. Do not create puddles. During application, observe the surface of the stone to assess the material’s absorbency. The stone is a natural product, so during the first impregnation, it is recommended to carry out a test in an invisible place in order to assess the stone’s absorbency and the effect obtained. Do not use the impregnation on resinous and non-absorbent surfaces. In the case of highly absorbent substrates, it is recommended to impregnate twice with an interval of about 30 minutes between operations.

NOTE: Shake the package each time before use until any white deposit is completely dissolved.

PREPARATION: Prior to application of sandstone sealer or natural stone sealer ensure surfaces to be sealed are clean, dry and free from contamination. If algae or stains are present pre-treat prior to cleaning with an appropriate cleaning product.

**If applied to a surface where a “sweep-in” pointing compound has been used within the last 6 months, the natural stone must be fully cleaned with Smartseal Residue Remover prior to sealant application.**

APPLICATION: A suitable pressure sprayer or roller is recommended taking care to avoid any pooling. Application on all substrates should be to full saturation and on vertical surfaces commence at the bottom and work upwards.

Remove any excess after approx 30 – 40 minutes.

One coat only is normally required, for best results. Do not apply in damp conditions or at temperatures below 12-15°c. Shake container well before use.

All equipment should be cleaned with water immediately after us